Combi shell mill holder SK 50 - 22 - 55

Combi shell mill holder SK 50 - 22 - 55Application: For mounting milling cutters with transverse or longitudinal groove. Delivery: With retaining screw, driving ring and feather key All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

With fi ne adjustment carriage to feed the slider finely

Execution:

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

- Tightness of the screw connection tested up to 80 bar

Angle reading and adjustment using a vernier

regardless of grade

Additional screw for DIN 2080 tools included

Instruction manual

coolant pipes is screwed to the cylinder head screw integrated in the adapter

For front surfacing and small diameters

Clamping positions: horizontal and vertical

With coolant channels for optimal coolant at the cutting edge