End mill holder Weldon BT 40 - 16 - 160

End mill holder Weldon BT 40 - 16 - 160Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

for mounting on a wall

Precision coolant supply: Improves chip evacuation and decreases the risk for chip jamming

The clamping screw is drilled through

5V AA Batteries * 3 ( Do not use low self-discharge battery )

parallelism: 0

Coolant supply via coolant flutes

Minimum internal diameter measurement capability of 20mm

with cooling channels

Instructions for useWrench4 pcs

critical factors for successful deep face grooving operations

Inch/Metric conversion

a clip and can be moved in steps of 25 mm