Monte Carlo Bar - Gen 2 (1967-1968)

Monte Carlo Bar - Gen 2 (1967-1968)Finally, a Monte Carlo bar that will fit your car without modifying the car! This bar will fit the 1967 1968 Mustang (possibly other years and models too) and it is designed to be adjustable so it will fit without the need of using hydraulics to widen the fenders or a welder to cut off the mounts, shorten the bar, and then weld the mounts back on. The bar and mount brackets are powder coated in Satin Black for a long lasting, durable finish and it

and with a lot of aftermarket shift boots available

75 inches (44

The Cap is powder coated black

5 for the S550 rear calipers

If you need 2

A must-have upgrade kit to dial in the chassis rigidity for your Classic Mustang

is to measure the distance from the center of one wheel cap threaded hole on the wheel to the far edge of the next wheel cap threaded hole

converting the fuel line to common -6AN fitting system

one fitting to connect the factory F100 brake line to this kit

for that stealth look

com/products/water-pump-pulley-cap-machined

Template is made in the USA and from a beefy piece of 1/8" Aluminum that can be used on many vehicles